MotoJacket

Find a Jacket to fit your motorcycle.

MotoJacket

Find the correct MotoJacket for your motorcycle.

Every MotoJacket order includes:

MotoJacket
OmniDry desiccant
Recycled rubber pad for kick stands and center stands
Instruction Booklet

Order NowDescription
Sport bikes and smaller
Full size bikes without a back rest or box on the back
Full dresser and road bikes with a back rest or large box on the back

Jacket Recommendations

GET THE MOST OUT OF YOUR JACKET

Inside Storage

Inside storage such as a garage, pole barn, or even dirt floor shed.

Dry Vehicle

An absolutely dry car or motorcycle. This means that you should not wash your vehicle just before storing.

Fabric Cover

Fabric cover that is dry and clean. This helps prevent against any scratches on the vehicle.

Storage Guide

 

STEP 1 Preparing Vehicle for Storage

Sweep floor and check tires to remove stones and grit that may damage the “jacket bottom”. If floor is not smooth, place tarp or other padding under jacket. Lay the jacket down and drive to the center. Place 1 packet of OmniDry on the jacket.

Step 2 Storing your Vehicle

Roll a clean, cool, dry motorcycle onto the cover and zip shut. Place kickstand on the rubber pad.Be prepared to see your motorcycle come from storage looking as it did when you put in.

Additional Information

WE’VE BEEN AROUND THE BLOCK

  • Your vehicle must be dry before put into the jacket
  • Do not wash on the day you plan to store your vehicle. Allow several days for thorough drying.
  • Do not drive on wet road or even wet grass just before storing.
  • Do not operate air conditioning before bagging as the evaporator may keep dripping water.
  • Repair all fluid leaks. Especially check fuel tank, fuel lines, radiator, water hoses and windshield washer system.
  • A freshly painted vehicle should not be bagged. Fresh paint should be properly dried/cured two to three months before storing a bike in any jacket.
  • Keep jacket interior clean by putting something under vehicle to catch drips as needed.
  • Be sure bike or car is cool. Never park or cover vehicle while engine/exhaust is hot. Jacket material could be damaged/melted.
  • Store your vehicle during low humidity whenever possible. Mid-afternoon on a dry day is best
  • Use a gas stabilizer like Sta-Bil.
  • Over-inflate tires 10 lbs. psi.
  • Check antifreeze for amount of cold protection.
  • Remove battery and clean with a baking soda and water mixture.
  • Save jacket box for future storage of jacket.
  • Save OmniDry box, plastic bag, and instruction card if you plan to dry desiccant for reuse. Some folks place them in jacket under vehicle.